How to Install Artificial Grass
Step One: Plan the Area
Before starting your project, plan out the area to be covered. Ensure that cables and water pipes are below the digging depth.
Remove the turf to a depth of 2″ using a turf cutter or spade and remove any large stones, bricks, or other obstructions. Lay down a type 1 stone base.
Step Two: Create an Edge
If there are no perimeters for the product to butt up against, install an edging system. We recommend Everedge which we offer from our head office. Knock the edging into the soil with a hammer and piece of wood: leave around 3cm exposed.
Chamfer the outer perimeters to a drop of 40mm from edging height to allow for a more natural look.
Step Three: Lay the Base
Apply around 6mm of granite dust or sharp sand where granite is not an option. Use a piece of timber to drag the sand or dust across the application area to provide a smooth surface. If using sand, the depth should not be more than 20mm, use hardcore to level out larger imperfections (i.e. over 20mm) before applying sand.
Step Four: Apply Weed Membrane
Once the base is compacted, apply weed membrane to the area. This will prevent weed growth whilst allowing water drainage. Trim off any waste membrane from the edges. If any joining is needed, overlap the edges then attach them with gaffer tape.
Step Five: Fit the Artificial Grass
Unroll the artificial turf over the area, being careful to not move the weed membrane. Having the pile direction running toward the house will give the best look from the windows of the house. Once positioned, trim the excess artificial grass. Everedge gives you a useful edge to run your knife around. We recommend changing blades every 3-5 metres to ensure the blade stays sharp enough.
Step Six: Finishing Touches
To finish, apply kiln sand to the turf. This can be done using a blower and stiff brush or a lawn fertilizer spreader. We recommend 6-8 kg of sand per square meter of product. This step is vital to ensure the most natural-looking finish. For the best results, we recommend brushing the pile before, during and after. This sand dressing should be done on a dry day and the same day as the lawn installation.